Reset 2002 Astra-G ECM Using OPCOM 2010V
2010V Can OBD2 OPCOM is primarily designed for almost all Opel vehicles diagnosis, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H and Zafira-B.
The next part is Kingbolen tell you how OPCOM 2010V Can OBD2 Opel reset ECM (Engine Control Module) for 2012 Astra-G. You must set ECM to its factory default state before a replacement / reset. In this case, you can install it in another car.
Connect OPCOM analysis tool for your vehicle and a laptop;
You can verify that the vehicle is fitted immobilizer - programmed immobilizer function is gray or not;
Open the asset;
Go to "Immo2 special functions" and you will see "Reset Engine Control Module 'is available;
Click the button and the swap will begin.
Important Note:
After using this function, you may not be able to start the engine.
Each factory default state engine ECU has some finite operation without immobilizer (max 10 attempts to be exact). After these, the engine ECU will lock and no more start is allowed without fully functional asset.
Before you exchange or replace any component related asset (ECU engine immobilizer ECU), you must reset the first.
Arming the immobilizer has some delay (usually 5 to 10 min), so that in five or ten minutes, you might be able to start the car. But after the expiry of this period, you will not be able to start the engine at all, as the asset will lock the vehicle. An indicator light (SVS, or MIL) flashes on the dashboard, showing a capital problem linked.
Kindly Note:
Never updated online OPCOM, the cause of the damage!
You can get $ 18 device series OPCOM back home, also offers products as related below: